Setting the preemption warning – Dell KVM 4161DS User Manual

Page 70

Controlling Your System at the Analog Ports

1 In the Scan dialog box, select the device to be removed.

Double-click on the device name or port.

Click the

Clear button to remove all devices from the scan list.

2 Click OK.

To start the scan mode:

1 Press

to launch the OSCAR interface. The Main dialog

box appears.

2 Click Commands. The Commands dialog box displays.
3 Select Scan Enable in the Commands dialog box.
4 Click X to close the Commands dialog box.

NOTE:

If the Add/Remove button is clicked when a device is highlighted, the check

box corresponding to the highlighted device toggles state.

To cancel scan mode:

1 Select a device if the OSCAR interface is open.

Move the mouse or press any key on the keyboard if the OSCAR interface

is not open. Scanning stops at the currently selected device.

Press . The

Main dialog box will appear.

2 Click Commands. The Commands dialog box displays.
3 Clear Scan Enable.

Setting the Preemption Warning

Administrators and users with equal or higher access rights than current user

can preempt (disconnect) KVM sessions and take control of the target device.

You can choose whether or not to warn the first user that the session will be

preempted and specify how long the appliance will wait for the first user to

respond to the warning.
To view or change the preemption warning settings, complete the following

steps:

1 Press to launch the OSCAR interface. The Main dialog

box appears.