Dell KVM 4161DS User Manual

Page 146

130

Managing Your Remote Console Switch Using the On-board Web Interface

3 In the PDU settings box, change the PDU name, set the cycle delay time,

enable or disable the current protection, enable or disable the audible

alarm and set the minimum amps and maximum amps in the

Inlet

Parameters field.

To configure a device connected to a PDU:

1 Click the Configure tab in the on-board web interface, then click the

PDUs category in the left column for a list of PDUs.

2 Click on the PDU you wish to access. The PDU Settings window opens.
3 Click the Outlet Settings button at the bottom of the PDU Settings

window for a list of devices connected to the PDU. The

Outlet Settings

window opens.

4 To modify an outlet name, complete the following steps:

In the Name column, click on the link for the outlet you wish to

change. The

Modify Power Outlet Name window opens.

If the device is a server, click Server, then select the name by clicking

on the appropriate entry in the

Server Name column of the table

-or-
If the device is not a server, click

Other Device, then enter the

appropriate text in the

Name text box.

Click Save, then click Close to return to the Outlet Settings window.

5 To modify the power-on interval, enter the value in seconds in the text box

in the

Power-On Interval column for the outlet being configured.

6 Click Save, then click Close to return to the PDUs window.

To power-control a device connected to a PDU:

1 Click the Configure tab in the on-board web interface, then click the

Outlets subcategory located under PDUs in the left column for a list of

available outlets.

NOTE: An outlet only appears in this list if a name has been associated with it.

2 Check the box next to the outlet(s) you wish to configure.
3 Click the On button to turn on the selected outlet(s).

- or -
Click the

Off button to turn off the selected outlet(s).