Dell Dimension L___cx - Manual (Page 62)

4-8 Dell Dimension L Series Systems Reference and Troubleshooting Guide
Hard-Disk Drives
If you have hard-disk drive problems, perform the following checks: checks:
•
For Windows 98 and Windows Me, run the ScanDisk utility by clicking the Start
button, pointing to Programs—> Accessories—> System Tools, and clicking
ScanDisk.
•
For Windows NT, run the error-checking utility by opening the property sheet of
the affected volume(s) and clicking
volume(s) and clicking Check Now w in the Error-checking section of
the Tools tab.
•
For Windows 2000, perform the following steps:
1. Double-click the My Computer icon located on the Windows desktop.
2. Click File, and then click Properties.
3. Click the Tools tab.
4. Under Error-checking, click Check Now Now.
5. Under Check disk options, click Scan for and attempt recovery of bad
sectors.
6. Click Start.
•
Run the appropriate tests under the IDE Devices E Devices device group as described in
“Running the Dell Diagnostics” found later in this chapter.
•
Check the settings on the IDE Configuration submenu of the system setup pro- ystem setup pro-
gram as described in Appendix B, “System Setup Program.”
•
Refer to “Hard-Disk Drive” in Chapter 6 for further troubleshooting information. Chapter 6 for further troubleshooting information.
Network
If you have network problems, perform the following steps:
1. Check the two status indicators on the computer’s back panel for activity.
•
The green indicator lights when the system is connected to a 100–megabit-
per-second (Mbps) network.
Mbps) network.
•
The yellow indicator flashes brightly when activity occurs on either a 100- or
10-Mbps network connection. The green indicator turns off when the system
is connected to a 10-Mbps network.
NOTE: If you can connect to the network but are having problems accessing : If you can connect to the network but are having problems accessing
network resources, contact your network administrator.