Dell Dimension L___cx - Manual (Page 49)

support.dell.com Installing Drives 3-7
2. Remove the bezel according to the instructions in “Removing and Replacing the
Bezel” found earlier in this chapter.
3. Remove the plastic insert from the bezel as described in “Removing and Replac-
ing a 3.5-Inch Front-Panel Insert” found earlier in this chapter.
4. Rotate the power supply according to the instructions in “Rotating the Power wer supply according to the instructions in “Rotating the Power
Supply Away From the System Board” in Chapter 2. While holding the power While holding the power
supply, stand the computer up.
5. Remove the metal plate covering the bay as shown in Figure 3-5. Using a screw-
driver, pop out the metal plate from the left or right side of the chassis.
Figure 3-5. Removing a 3.5-Inch Drive Bay Plate
6. Remove the extra rails (see Figure 3-6) from the inside of the front of the chassis.
Install the rail marked “L” on the left side of the drive and the rail marked “R” on
the right side of the drive.
drive bay plate