Dell POWEREDGE M1000E - Manual (Page 271)

Fabric OS MIB Reference 253
53-1001768-01
connUnitPortControl 1.3.6.1.3.94.1.10.1.16
8
• bypassConnUnitPort
If the addressed connUnit allows this operation to be performed to this port, the addressed
port performs a vendor-specific “bypass” operation.
Examples of these operations are:
• Transitioning from online to offline.
• A request (NON-PARTICIPATING) command to the loop port state machine.
• Removal of the port from an arbitrated loop by a hub.
• unbypassConnUnitPort
If the addressed connUnit allows this operation to be performed to this port, the addressed
port performs a vendor-specific “unbypass” operation. Examples of these operations are
• The Link Failure protocol.
• A request (PARTICIPATING) command to the loop port state machine.
• Addition of the port to an arbitrated loop by a hub.
• offlineConnUnitPort
If the addressed connUnit allows this operation to be performed to this port, the addressed
port performs a vendor-specific offline operation.
Examples of these operations are:
• Disabling a port's transceiver.
• The Link Failure protocol.
• Request (NON-PARTICIPATING) command to the loop port state machine removal of the
port from an arbitrated loop by a hub.
• onlineConnUnitPort
If the addressed connUnit allows this operation to be performed to this port, the addressed
port performs a vendor-specific online operation.
Examples of these operations are:
• Enabling a port's transceiver.
• The Link Failure protocol, request (PARTICIPATING) command to the loop port state
machine.
• Addition of the port from an arbitrated loop by a hub.
Each implementation might choose not to allow any or all of these values on a SET.
If the management station uses in-band communication (FC-IP) with the switch, either of
the two following actions might result in a loss of in-band communication with the switch.
• Disabling the FC port that is connected to the management station
• Disabling the embedded port