Dell POWEREDGE M1000E - Manual (Page 34)

16 Fabric OS MIB Reference
53-1001768-01
Access Gateway and Brocade MIBs
1
SNMP GET Security Level: Authentication and Privacy
SNMP SET Security Level: Authentication and Privacy
4. In the Manager (SNMP Browser), create a user snmpadmin1 with Authentication protocol as
noAuth, Privacy protocol as noPriv, set the password and set the trap port as 162. (Same
values are set as in the switch SNMPv3 configuration.)
Access Gateway and Brocade MIBs
Brocade Access Gateway supports the following MIBs ( Table 3 )
.
Firmware upgrades and enabled traps
The pre- Fabric OS v4.4 firmware had trap group level settings i.e, traps were turned on and off as a
group. In Fabric OS v4.4 or later, you can turn on and off traps individually within a trap group.
When you upgrade to the Fabric OS v4.4 firmware or later, by default the individual traps are turned
off even if the corresponding trap group was enabled before upgrading. So you must use the
snmpconfig command to turn on explicitly the individual traps within each trap group.
TABLE 3 Access Gateway MIB support
MIB name Supported Description
MIB-2 Yes Updated to support Access Gateway in v5.2.1.
Entity-MIB Yes
HA-MIB Yes
SW-MIB No Disabled in Access Gateway because the conventions are specific to
fabric switches.
FA-MIB Yes The connUnitSnsTable is not supported because a switch in Access
Gateway does support name server services.
FE-MIB No Disabled in Access Gateway because the conventions are specific to
fabric switches.
CPQ-Rack MIB Limited Supported on embedded switches only.
FCIP MIB Limited Implemented to support WAN interfaces in Fabric OS v5.3.0.
iSCSI MIB Limited Supports displaying information about virtual targets (VTs), iSCSI
sessions, and TCP connection tables, as derived from specific MIB
tables.
IF-MIB Yes
BD-MIB Yes Supported for F-ports.