Removing a memory card or blank – Dell XPS M1330 (M1330, Mid 2007) User Manual
Page 72
72
Using the Memory Card Reader
CAUTION:
Before you begin any of the procedures in this section, follow the
safety instructions in the Product Information Guide.
To install a memory card:
1 Hold the card with the top side of the card facing up.
2 Slide the card into the slot until the card is completely seated in its
connector.
NOTE:
If you encounter too much resistance, do not force the card. Check the
card orientation and try again.
The computer recognizes the memory card and automatically loads the
appropriate device driver. If the configuration program tells you to load the
manufacturer's drivers, use the media that came with the memory card, if
applicable.
Removing a Memory Card or Blank
CAUTION:
Before you begin any of the procedures in this section, follow the
safety instructions in the Product Information Guide.
Press the card into the slot to release it from the memory card reader. When it
is partially ejected, remove the card.
book.book Page 72 Tuesday, October 7, 2008 6:00 PM