Dell PowerEdge SC1435 - Manual (Page 78)

78
Troubleshooting Your System
Troubleshooting an Optical Drive
Problem
• System cannot read data from a CD or DVD in an optical drive.
• Optical drive indicator does not blink during boot.
NOTE:
DVD devices are data only.
Action
CAUTION:
Only trained service technicians are authorized to remove the system cover and access any of the
components inside the system. Before performing any procedure, see your Product Information Guide for
complete information about safety precautions, working inside the computer and protecting against electrostatic
discharge.
1 Try using a different CD or DVD that you know works properly.
2 Enter the System Setup program and ensure that the drive’s IDE controller is enabled. See "Using the
System Setup Program" on page 23.
3 Run the appropriate online diagnostic test. See "Using Dell PowerEdge Diagnostics" on page 85.
4 Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.
5 Open the system. See "Opening and Closing the System" on page 38.
6 Ensure that the interface cable is securely connected to the optical drive.
7 Close the system. See "Opening and Closing the System" on page 38.
8 Reconnect the system to the electrical outlet, and turn on the system and attached peripherals.
If the problem is not resolved, see "Getting Help" on page 95.
Troubleshooting a Hard Drive
Problem
• Device driver error.
• One or more hard drives not recognized by the system.
Action
CAUTION:
Only trained service technicians are authorized to remove the system cover and access any of the
components inside the system. Before performing any procedure, see your Product Information Guide for
complete information about safety precautions, working inside the computer and protecting against electrostatic
discharge.