Dell PowerEdge SC1435 - Manual (Page 91)

Jumpers and Connectors
91
7 Turn off the system, including any attached peripherals, and disconnect the system from the electrical
outlet.
8 Open the system. See "Opening and Closing the System" on page 38.
9 Install the jumper plug on the password jumper.
10 Lower the memory module shroud.
11 Close the system.
12 Reconnect your system and peripherals to their electrical outlets, and turn on the system.
13 Assign a new system and/or setup password.
To assign a new password using the System Setup program, see "Assigning a System Password" on
page 30.