beautypg.com

Display – Dell Inspiron 4150 User Manual

Page 12

background image

Back to Contents Page

Display, Display Assembly, Display Latch, and Hinge Covers

Dell™ Inspiron™ 4150 

  

Display

  

Display Assembly

  

Display Latch

  

Hinge Covers

Display

1.

 

Remove the

hard drive

.

2.

 

Remove the

center control cover

.

3.

 

Remove the

keyboard

.

4.

 

Close the display.

5.

 

From the back of the computer, remove the five M2.5 x 5-mm screws labeled "circle D."

6.

 

Open the display approximately 180 degrees and support the display so that it does not open past this position.

7.

 

Remove the two M2 x 3-mm screws on the EMI shield bracket, which is attached to the display-feed flex cable.

8.

 

Remove the two M2 x 3-mm screws that secure the display-feed flex cable to the system board.

NOTICE:

You must remove the display before you remove the palm rest.

NOTICE:

Disconnect the computer and any attached devices from electrical outlets, and remove any installed batteries.

NOTICE:

To avoid ESD, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface on the computer.

NOTICE:

Read "

Preparing to Work Inside the Computer

" before performing the following procedure.

1 M2 x 3-mm screws (4)

2 top cover

3 center control cover

4 M2.5 x 5-mm screws (5)

5 bottom case

6 EMI shield bracket

NOTICE:

When reconnecting the display-feed flex cable connector to the system board, push down on the top-left and top-right ends of the connector.

Pressing on the center of the connector may damage resistors and compromise EMI protection in the computer.