Dell PowerEdge 2970 - Manual (Page 55)

Installing System Components
55
Figure 3-3. Removing the Front Bezel
Replacing the Front Bezel
To replace the front bezel, perform the above steps in reverse.
Opening and Closing the System
CAUTION:
Only trained service technicians are authorized to remove the system cover and access any of the
components inside the system. See your Product Information Guide for complete information about safety
precautions, working inside the computer, and protecting against electrostatic discharge.
Opening the System
To upgrade or troubleshoot the system, remove the system cover to gain access to internal components.
1 Unless you are installing a hot-plug component such as a cooling fan or power supply, turn off the
system and attached peripherals, and disconnect the system from the electrical outlet and peripherals.
2 To remove the system cover, turn the latch release lock counter-clockwise to the unlocked position. See
Figure 3-4.
3 Lift up on the latch on top of the system. See Figure 3-4.
4 Grasp the cover on both sides and carefully lift the cover away from the system.
1 bezel lock 2 control panel LCD
2
1