Figure 6-1 for jumper location, Boot the system. see figure 6-1 for – Dell PowerEdge 2970 User Manual

Page 140

Text mode
Original mode

140

Jumpers and Connectors

Figure 6-1.

System Board Jumpers

Table 6-1.

System Board Jumper Settings

Jumper

Setting

Description

NVRAM_CLR

(default) The configuration settings are retained at system boot.

The configuration settings are cleared at the next system
boot. (If the configuration settings become corrupted to
the point where the system will not boot, install the
jumper and boot the system. Remove the jumper before
restoring the configuration information.)

PWRD_EN

(default) The password feature is enabled.

The password feature is disabled.

NOTE:

For the full name of an abbreviation or acronym used in this table, see the "Glossary" on page 175.