beautypg.com

Sas controller daughter card, Replacing the fan bracket, Installing a sas controller daughter card – Dell PowerVault DP500 User Manual

Page 33

background image

 

Replacing the Fan Bracket

 

1.

Insert the two tabs on the right side of the fan bracket into the two slots on the system board tray.

 

2.

Gently rotate the left end of the fan bracket downward into the system until the release latch and plastic clip fully engage.

 

3.

Reinstall the SAS controller daughter card. See

Installing a SAS Controller Daughter Card

.


 

4.

Replace the fans in the fan bracket. See

Replacing a Cooling Fan

.


 

5.

Close the system. See

Closing the System

.


 

6.

Reconnect the system to the electrical outlet and turn on the system and attached peripherals.

 

SAS Controller Daughter Card

Your system includes a dedicated slot on the sideplane for a SAS controller daughter card. The SAS controller daughter card provides the SAS storage
subsystem for your system's internal hard drives. The optional SAS RAID controller daughter card allows you to set up any internal hard drives in a RAID
configuration. Although the cabling for the two types of daughter cards is different (the SAS controller daughter card has only one connector, while the SAS
RAID controller daughter card has two), both cards install into the sideplane as described below. The SAS RAID controller daughter card is shown in

Figure 3

-

12

.

 

Installing a SAS Controller Daughter Card

 

1.

Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.

 

2.

Open the system. See

Opening the System

.


 

3.

Disconnect the control panel cable from the sideplane board. See

Removing the Control Panel Assembly

.


 

4.

Hold the SAS daughter card by its edges with the card connector facing the sideplane board.

 

5.

Aligning the chassis slots on the SAS daughter card tray with the corresponding hooks on the chassis, insert the card connector into the SAS daughter
card connector on the sideplane board. See

Figure 3

-12

.

Ensure that the card is aligned with the mid-section standoff on the SAS controller daughter card and fully seat the card in the sideplane board.

 

Figure 3-12. Installing a SAS Controller Daughter Card

1

release latch

2

fan bracket

3

plastic clip

4

fan bracket slot in power supply cage

5

tabs (2)

 

 

NOTICE:

Do not press on the RAID card DIMM while installing the RAID card into the sideplane board.

NOTE:

If you are installing a replacement RAID card, do not remove the plastic cover protecting the card until after installation of the card is complete.