beautypg.com

Dell XPS M140 (MXC051, Late 2005) User Manual

Page 78

background image

78

Solving Problems

www

.del

l.

com |

su

ppo

rt.

d

e

ll.

co

m

The computer runs the Pre-boot System Assessment, a series of initial tests of your system

board, keyboard, hard drive, and display.
• During the assessment, answer any questions that appear.
• If a failure is detected, the computer stops and beeps. To stop the assessment and restart

the computer, press ; to continue to the next test, press ; to retest the

component that failed, press .

• If failures are detected during the Pre-boot System Assessment, write down the error

code(s) and contact Dell.

If the Pre-boot System Assessment completes successfully, you receive the message Booting
Dell Diagnostic Utility Partition. Press any key to continue.

4 Press any key to start the Dell Diagnostics from the diagnostics utility partition on your

hard drive.

Starting the Dell Diagnostics From the Drivers and Utilities CD

NOTE:

The Drivers and Utilities CD may be optional and may not ship with your computer.

1 Insert the Drivers and Utilities CD.
2 Shut down and restart the computer.

When the DELL logo appears, press immediately.
If you wait too long and the Windows logo appears, continue to wait until you see the

Windows desktop. Then shut down your computer and try again.

NOTE:

The next steps change the boot sequence for one time only. On the next start-up, the computer

boots according to the devices specified in the system setup program.

3 When the boot device list appears, highlight CD/DVD/CD-RW Drive and press .
4 Select the Boot from CD-ROM option from the menu that appears and press .
5 Type 1 to start the ResourceCD menu and press to proceed.
6 Select Run the 32 Bit Dell Diagnostics from the numbered list. If multiple versions are listed,

select the version appropriate for your computer.

7 When the Dell Diagnostics Main Menu appears, select the test you want to run.

book.book Page 78 Wednesday, October 26, 2005 1:00 PM