Dell PowerEdge R815 - Manual (Page 122)

122 Installing System Components
3 Remove the plastic filler plug for the iDRAC6 Enterprise port from the
system back panel. See Figure 1-3.
4 Align the front edge of the card with the two plastic retention standoffs
next to the iDRAC6 connector on the system board, and lower the card
into place. See Figure 3-21 and Figure 6-1.
When the front of the card is fully seated, the plastic standoffs snap over
the edge of the card.
5 If applicable, connect the Ethernet cable from the iDRAC6 Enterprise
Card connector on the system back panel. See Figure 1-3.
6 Close the system. See "Closing the System" on page 77.
7 Reconnect the system to its electrical outlet and turn the system on,
including any attached peripherals.
8 Enter the iDRAC6 configuration utility and set up the Ethernet mode. See
"iDRAC6 Configuration Utility" on page 71.
VFlash Media (Optional)
The VFlash media card is a Secure Digital (SD) card that plugs into the
optional iDRAC6 Enterprise card at the back corner of the system.
Removing a VFlash Media Card
To remove the VFlash media, push inward on the card to release it, and pull
the card from the card slot.
Installing a VFlash Media Card
1 Locate the VFlash media slot at the back corner of the system. See
Figure 1-3.
2 With the label side facing up, insert the contact-pin end of the SD card
into the card slot on the module.
NOTE: The slot is keyed to ensure correct insertion of the card.
3 Press inward on the card to lock it into the slot.
book.book Page 122 Wednesday, December 18, 2013 2:48 PM