beautypg.com

Step 2 – Dell PowerVault 221S (SCSI) User Manual

Page 20

background image

Removing and Installing Hard Drives: Dell PowerVault 220S and 221S Systems Installation and Troubleshooting Guide

file:///C|/Users/rishi_sood/Desktop/220s/en/it/6f704c3a.htm[3/7/2013 12:07:20 PM]

b. Separate the rail from the shield with enough space to insert the access pins.

c. Find the two holes on the slide rail labeled "S" and insert access pins in the holes by pressing the pins through

from the inside of the rail (see

Figure 3-3

).

Figure 3-3. Configuring a SCSI Drive Carrier

d. Reassemble the slide rail to the carrier shield and bend the metal retaining tab back into place.

2. Perform the following steps to install the new hard drive into the carrier:

a. If you are replacing a hard drive in the carrier, remove the four screws that secure the hard drive to its carrier

(see

Figure 3-4

).

b. Position the replacement hard drive into the hard-drive carrier with the hard drive's controller board facing the

carrier shield.

This manual is related to the following products: