Dell 3100cn Color Laser Printer - Manual (Page 180)

*1 An optional multi protocol card is required to use.
NetWare
Purpose:
To configure detailed settings for IPX/SPX and NetWare.
Values:
IP Address
Mode AutoIP Automatically sets the IP address.
DHCP Uses DHCP to set the IP address.
BOOTP Uses BOOTP to set the IP address.
RARP Uses RARP to set the IP address.
Manually
Set Enables the IP address set in IP Address.
IP Address Sets the IP address allocated to the printer in the nnn.nnn.nnn.nnn format. Each section of nnn.nnn.nnn.nnn is a
value between 0 and 254. Note that values 127 and 224 to 254 are not valid for the first three-digits.
Subnet Mask Sets the subnet mask in the nnn.nnn.nnn.nnn format. Each section of nnn.nnn.nnn.nnn is a value between 0 and
255. Note that 255.255.255.255 is invalid.
Gateway Address Sets the gateway address in the nnn.nnn.nnn.nnn format. Each section of nnn.nnn.nnn.nnn is a value between 0
and 254. Note that values 127 and 224 to 254 are not valid for the first three-digits.
DNS DNS Mode Select the check box to get the DNS server address automatically from the DHCP server.
DNS Server ADDR Sets the DNS server address.
WINS* 1 WINS Mode Select the check box to get the WINS server address automatically from the DHCP server.
WINS Primary Server Sets WINS server address in the nnn.nnn.nnn.nnn format. Each section of nnn.nnn.nnn.nnn is a value between 0
and 254. Note that values 127 and 224 to 254 are not valid for the first three-digits.
WINS Secondary Server Sets a back up WINS server address in the nnn.nnn.nnn.nnn format. Each section of nnn.nnn.nnn.nnn is a value
between 0 and 254. Note that values 127 and 224 to 254 are not valid for the first three-digits.
LPD Connection Time-Out Sets the connection timeout period from 1 to 1000 seconds.
IP Filter To set the IP Filter settings, click IP Filter. The " IP Filter " page is displayed.
Port9100 Port Number Sets the port number from 9000 to 9999.
Connection Time-Out Sets the connection timeout period between 1 and 1000 seconds.
IP Filter To set the IP Filter settings, click IP Filter. The " IP Filter " page is displayed.
IPP* 1 Printer URI Displays the printer URI.
Connection Time-Out Sets the connection timeout period from 1 to 1000 seconds.
Port Number Displays the port number for receiving requests from the client.
Maximum Sessions Displays the maximum number of connections received simultaneously by the client.
HTTP Port Number Sets the port number to 80 and 9000 to 9999.
Simultaneous
Connections Displays the maximum number of connections received simultaneously by the client.
Connection Time-Out Sets the connection timeout period from 1 to 255 seconds.
FTP Password Sets whether to enable or disable the password. And also specifies the password value up to seven characters.
Connection Time-Out Sets the connection timeout period from 1 to 1000 seconds.
IPX/SPX Frame
Type
Auto Specifies the active frame type automatically.
Ethernet II Selects Ethernet II frame type.
Ethernet 802.3 Selects IEEE802.3 frame type.
Ethernet 802.2 Selects IEEE802.2 frame type.
Ethernet SNAP Selects SNAP frame type.
Current Frame Type Displays the current frame type.