Crestron electronic Green Light GLPS-HSW-FT - Manual (Page 68)

Crestron Commercial Lighting Design Guide
64
Shades
C2N--SDC--DC
The C2N-SDC-DC is a 2-channel shade and drape controller designed to provide a
convenient and cost-effective solution for controlling 24V DC motorized shades
and drapes.
The C2N-SDC-DC is a Cresnet device with two independently controlled 24V DC
outputs, each designed to provide standard up/down or open/close control of a
conventional two-wire bidirectional type motor.
The C2N-SDC-DC mounts in the wall or ceiling using an off-the-shelf 4" square or
2-gang electrical box. Pushbuttons on the front of the unit allow for manual
operation of the motors during installation and setup.
C2N--SSC--2
The C2N-SSC-2 Somfy Shade Controller is a compact Cresnet device designed to
provide a bidirectional serial interface for up to two Somfy ILT Intelligent Shade
Motors. Window treatments equipped with the Somfy ILT motor offer enhanced
capability compared to typical 3-wire models.
In addition to basic open/close commands, the C2N-SSC-2 allows for setting each
shade to a specific position and polling for its current position with 16-bit
precision. Feedback signals provide confirmation of each motor's activity to
enable precise, predictable control, even from a remote location. Limit
adjustments are set electronically using buttons provided on the face of the unit,
and up to 20 presets for each output can be saved onboard the C2N-SSC-2 for
easy recall through the control system. The C2N-SSC-2 mounts discreetly to any
flat surface and requires a simple Cresnet connection to the control system.
DIN--2MC2
The DIN-2MC2 is a 2-channel motor control module designed to provide control of
bidirectional motors for drapes, shades, projection screens, lifts, skylights, and
gates. Each channel supports up/down or open/close control of a conventional 3-
wire bidirectional type motor up to ½ HP. Built-in timing and interlock logic make
it easy to program the DIN-2MC2 for failsafe operation.
> Dual-channel bidirectional motor control
> Supports 120 to 240 volt 50/60 Hz
> Setup via front panel or software
> Mounts in a DIN rail cabinet or CAEN enclosure with adapter
4.1 in
(10.42 cm)
4.1 in
(10.42 cm)
3.83 in
(9.73 cm)
2.14 in
(5.44 cm)