Crestron electronic Green Light GLPS-HSW-FT - Manual (Page 30)

Crestron Commercial Lighting Design Guide
26
Power Switching
G GLXP-HSW8 and GLXP-HSW12
The GLXP-HSW8 and GLXP-HSW12 are Crestron Green Light switching modules which features 8 or 12 channels of high-inrush power
switching with rugged, high-current latching relays. The modules are part of a complete Crestron engineered GLPS Green Light
switching panel.
> 8 or 12 channels of high-inrush power switching
> Rugged, high-current latching relays
> Supports 100 to 277 Volt applications
> 16 Amp, 1 HP load rating per channel
> Arcless switching
> Positive air gap at each output
> Phase-independent channels
> Cresnet communications
> Redundant power capability—module powered via line or
Cresnet
> Local controls for testing and verification
> Local and remote override capability
> Non-volatile power failure memory
Load Ratings
Switch Channels 8 or 12
Per Channel 16 Amps at 100-277 Volts AC, 50/60 Hz
0.5 HP @ 120 Volts, 1 HP @ 230 Volts, 1 HP @ 277 Volts
Switch Load Types Incandescent, Magnetic Low-Voltage, Electronic Low-Voltage, Neon/Cold Cathode, Fluorescent
Ballast, High-Intensity Discharge, Motor
Relay Lifetime 1,000,000 on/off operations at full electronic ballast load
Power Requirements
Primary 100-277 Volts AC, 50/60Hz, supplied via channel 1 (L1, N1)
Secondary (optional) 5 watts at 24 Volts DC, supplied via Cresnet®
Environmental
Temperature 32° to 104°F (0° to 40°C)
Humidity 10% to 90% RH (non-condensing)
Heat Dissipation HSW8: 112 BTU/Hr
HSW12: 160 BTU/Hr
Electrical Regulatory Certifications
UL508, Section 41 (Endurance Test) and Section 61C (Electronic Ballasts)
UL924, Emergency Power Equipment
IEC60669-2-1, Section 19.102 (Contact mechanisms incorporated in electronic switches, intended for fluorescent lamp circuits or
other capacitive loads)
Module SCCR Rating - 18kA
CE