Baumer G1-G2-GB-GXxxx - Manual (Page 7)

Manual_ProGeber_V1-40_EN.doc 7/40 Baumer IVO GmbH & Co. KG
10.05.11 Villingen-Schwenningen, Germany
3 The program ProGeber
3.1 Basic information
The program ProGeber is a software for programming Baumer IVO encoders. It enables the
reading out, the modification and the display of encoder data. Hereby the encoder parameters
can be read out, altered, programmed and displayed. To make the programming as easy as
possible, the user can select valid fields only. Fields that cannot be selected are highlighted in
grey. Before the encoder can be programmed, the type of encoder must be selected. Thus a
logical program run is achieved after starting the program:
1. Step
Select language via the respective country's flag
2. Step Select type of encoder by clicking the button "Select encoder"
3. Step Programming can be started
If your encoder cannot be detected automatically and is not included in the selection menu as
well, please contact Baumer IVO GmbH & Co. KG.
3.2 Program run
After the opening image the following mask will appear:
The programming can only be started after selecting a type of encoder. The selection of the
encoders is described in the chapters „Encoder connected to PC
⇒ Automatic selection" and
„Select type of encoder from table ⇒ Manual selection".