Baumer G1-G2-GB-GXxxx - Manual (Page 15)

Manual_ProGeber_V1-40_EN.doc 15/40 Baumer IVO GmbH & Co. KG
10.05.11 Villingen-Schwenningen, Germany
4.1.3 Extras
Call up data:
The data is called up from the connected encoder
Send data: The current programming is saved in the encoder
Display position: The display mask is opened
(see chapter 4.5 „position display“)
Set position: The mask for assignment of any value desired is being opened.
(see chapter 4.6 Explanation „Set position“)
Teach in: The mask for the automatic scaling is displayed
(see chapter 4.7 „Explanation Teach in“)
Reset: The encoder is programmed to basic setting
Caution: Old encoder data will be overwritten!
Address encoder: The address set at the connected encoder is called up or set.
The mask may vary according to the corresponding encoder model