Heart rate monitor – Garmin Forerunner 310XT User Manual
Page 42
3
Forerunner 310XT Owner’s Manual
Using Accessories
Heart Rate Monitor
For information about putting on the
heart rate monitor, see
Heart Rate Monitor Tips
If you are noticing inaccurate
or erratic heart rate data, use the
following tips.
Make sure the heart rate monitor
is snug against your body.
Reapply water, saliva, or
electrode gel to the electrodes.
Clean the electrodes. Dirt and
sweat residue can interfere with
heart rate signals.
Wear a cotton shirt or wet your
shirt if suitable for your activity.
Synthetic fabrics that rub or flap
against the heart rate monitor
can create static electricity that
interferes with heart rate signals.
Move away from sources of
strong electromagnetic fields and
some 2.4 GHz wireless sensors,
•
•
•
•
•
which can interfere with your
heart rate monitor. Sources of
interference may include very
high voltage power lines, electric
motors, microwave ovens,
2.4 GHz cordless phones, and
wireless LAN access points.
Replacing the Heart Rate
Monitor Battery
The heart rate monitor contains a
user-replaceable CR2032 battery.
note: Contact your local waste
disposal department to properly
dispose of batteries.
1. Use a small Phillips screwdriver
to remove the four screws on the
back of the module.
2. Remove the cover and battery.
Wait 30 seconds. Insert the new
battery with the positive side
facing up.
note: Be careful not to damage
or lose the O-ring gasket.