Bio-Rad T100™ Thermal Cycler - Manual (Page 8)

vi
• EN 61010-2-010:2003 Safety requirements for electrical equipment for
measurement, control, and laboratory use —Part 2-010: Particular requirements
for laboratory equipment for the heating of material
• UL 61010-1:2004(R2008) Safety Requirements for Electrical Equipment for
Measurement, Control, and Laboratory Use —Part 1: General Requirements
• UL 61010A-2-010:2002 Standard for Electrical Equipment for Laboratory Use;
Part 2: Particular Requirements for Laboratory Equipment for the Heating of
Material
ELECTROMAGNETIC COMPATIBILITY (EMC)
• IEC61326-1:2005 Electrical Equipment for measurement, control, and laboratory
use —EMC Requirements, Class A
• EN61326-1:2006 Electrical Equipment for measurement, control, and laboratory
use —EMC Requirements, Class A
• FCC Part 15, Subpart B, Sections 15.107 and 15.109 as a Class A digital device.
FCC WARNINGS AND NOTES
WARNING! Warning: Changes or modifications to this unit, not expressly approved
by Bio-Rad Laboratories, could void the user’s authority to operate the equipment.
• Note: This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to
cause harmful interference in which case the user will be required to correct the
interference, at his own expense.
• Note regarding FCC compliance: Although this instrument has been tested and
found to comply with Part 15, Subpart B of the FCC Rules for a Class A digital
device, please note that this compliance is voluntary, for the instrument qualifies
as an “exempted device” under 47 CFR 15.103(c), in regard to the cited FCC
regulations in effect at the time of manufacture.
• Note regarding Canadian EMC compliance: Le present appareil numerique
n’emet pas de bruits radioelectrique depassant les limites applicables aux
appareils numeriques de class A prescrites dans le reglement sur le brouillage
radioelectrique edicte par le Ministere des Communications du Canada.