Using the cfx automation system ii, Introduction, Test the calibration using the calibration wizard – Bio-Rad CFX Automation System II User Manual
Page 29: G a test automation run
CFX Automation System II
| 21
Read this chapter for information about using the CFX Automation System II.
■
n
Introduction
■
n
■
n
Adding Plates after Starting an Automation Run
■
n
■
n
Pausing or Canceling a Single Plate Run in a CFX System
■
n
■
n
■
n
■
n
Create the Plate List: Additional Features
■
n
Barcode Controls: Advanced Features
■
n
■
n
■
n
Introduction
CFX Automation Control Software and CFX Manager
™
Software are used together to
automate CFX System(s). The automation software controls the plate handler and is the main
interface for controlling all automation processes. CFX Manager Software is used to create
plate setup files and cycling protocols, control the CFX System thermal cycling processes,
and analyze data. Refer to the CFX System instruction manual (bulletin #10021337) for
detailed information about CFX Manager Software. To use CFX Manager Software and the
automation software simultaneously, CFX Manager Software must be opened prior to
the automation software.
Using the CFX Automation
System II
2