Baseline Systems FlowStation - Manual (Page 7)

Baseline FlowStation User Manual
2 – Installing Shared Flow Components
Installing the FlowStation and Communication Module
Install the FlowStation enclosure and the communication module according to the instructions that
came with the equipment.
Make sure the FlowStation is powered up and the communication module is connected.
To find the required tasks for setting up the FlowStation, refer to the section on Configuring the
FlowStation on page 11 of this User Manual.
Installing the Shared Flow biCoders
Connect a 3200UPG-SF biCoder to the two-wire path of each BaseStation 3200 irrigation controller
that will be part of the shared flow group. Refer to the installation guide that came with the
biCoder.
The BaseStation 3200 controller recognizes that the Shared Flow biCoder has been installed, and
the controller enables the shared flow features.
Installing the BaseStation 3200 Irrigation Controllers
Refer to the BaseStation 3200 User Manual to install and set up the controllers.
To find the required tasks for setting up the BaseStation 3200 to use shared flow, refer to the
section on Configuring the BaseStation 3200 Irrigation Controller for Shared Flow on page 4 of this
User Manual.
2 – Installing Shared Flow Components Page 3