Baseline Systems FlowStation - Manual (Page 28)

Baseline FlowStation User Manual
3. Perform the steps in Viewing the IP Information Screen on page 22. Write down the number
that displays in the IP Address field.
Example: 10.11.12.88
4. Start a web browser on a computer or other device that is connected to the FlowStation
network.
5. In the web browser’s address field, perform one of the following actions:
 If the Force SSL field IS selected, type HTTPS://
 If the Force SSL field is NOT selected, type HTTP://
6. In the web browser’s address field, following either HTTPS:// or HTTP://, type the IP Address
that you recorded in step 3 of this procedure, and then press Enter.
Example: HTTPS://10.11.12.88
7. Perform one of the following actions:
 If you did not require a PIN when you set up the web server, the Local LiveView page for
your FlowStation displays in the browser. Continue with step 8.
 If you required a PIN when you set up the web server, the browser will prompt you to
enter a username and password. Leave the Username field as is. Click in the Password
field, and then type the PIN. Click the OK button or press Enter. The Local LiveView page
for your FlowStation displays in the browser as illustrated below.
8. In the browser, use the mouse to click a button on the Local LiveView interface. All commands
issued through LiveView are performed on the FlowStation.
9. When you have finished using Local LiveView, close the browser window to prevent
unauthorized users from operating the FlowStation.
Page 24 4 – Configuring the FlowStation