Baseline Systems FlowStation - Manual (Page 20)

Baseline FlowStation User Manual
Assigning Points of Connection (POC)
IMPORTANT! You must enable shared flow for the POC in the BaseStation 3200 before you
can assign the POC in the FlowStation. Refer to Enabling Shared Flow for a POC on the
BaseStation 3200 on page 8.
1. On the FlowStation, press the Search & Assign button. The Assign menu displays.
2. Press the  button to highlight the POC option, and then press the OK button to select it. The
POC menu displays.
3. If the Device Assignment option is highlighted, press the OK button to select it. If Device
Assignment is not highlighted, press the  or  button to highlight it, and then press the OK
button. The POC Assignment screen displays. The POCs that have been enabled for shared
flow in the controllers are listed in the Action column by the controller’s serial number
followed by the POC number.
Example: 3K80000:1
4. Press the  or  button to move through the list of POCs in the Action column. Highlight the
number of the POC that you want to assign to the shared flow group.
5. Press the  button to move to the POC column.
6. Press the  or  button to move through the list of POCs. Highlight the number that you
want to assign the POC to.
7. Press the OK button to select the highlighted POC number. The number of the POC that you
selected in the Action column now displays next to the number in the POC column.
Note: The next serial number in the Action column is automatically highlighted. Press the 
or  button in the POC column to move to the next zone that you want to assign, and then
press the OK button.
8. Continue until you have assigned all your POCs to the shared flow group.
Enabling/Disabling an Assigned Point of Connection (POC)
1. On the FlowStation, press the Search & Assign button. The Assign menu displays.
2. Press the  button to highlight the POC option, and then press the OK button to select it. The
POC menu displays.
3. Press the  button to highlight the Device Setup option, and then press the OK button to
select it. The POC Device Setup screen displays.
4. In the first column, press the + or – button to select the number of the POC that you want to
enable or disable.
5. Press the  button to move to the Enabled field. A checkmark in the field means that the
POC is enabled in the FlowStation. A blank field means that the POC is disabled. To change the
setting, press the OK button.
Page 16 4 – Configuring the FlowStation