Baseline Systems Ethernet Radio User Manual
Ethernet radio configuration guide, For gateway, endpoint, and repeater radio units
Table of contents
Document Outline
- Section 1 – Configuring the Radios
- Step 1 – Ask Your Network Administrator for LAN Network Settings
- Step 2 – Complete the Ethernet Radio Configuration Worksheet
- Step 3 – Install the Radio Equipment and Antennas
- Step 4 – Verify Radio Communication over the Stand-Alone Network
- Step 5 – Download the Discovery Server Executable to the Laptop Computer
- Step 6 – Configure the Settings on the Ethernet Radios
- Step 7 – Verify that the Controllers Are Connected to BaseManager
- Section 2 – Adding a Repeater
- Step 1 – Map Out the Subnet IDs for the Network
- Step 2 – Install the Repeater Ethernet Radio at the Site
- Step 3 – Find the IP Addresses for the Radios
- Step 4 – Configure the Settings for the Endpoint that is Called through the Repeater
- Step 5 – Configure the Settings for All Other Endpoints in the Network
- Step 6 – Configure the Settings for the Repeater
- Step 7 – Configure the Settings for the Gateway
- Step 8 – Verify that the Controllers Are Connected to BaseManager
- Section 3 – Using the Configuration Web Server
- Connecting to the Configuration Web Server
- Ethernet Radio Settings Reference
- Changing the Computer’s IP Address in Windows
- Appendix