Baseline Systems Ethernet Radio - Manual (Page 23)

Ethernet Radio Configuration Guide
Section 3 – Using the Configuration Web Server Page 17
Save Your Changes
Click the Save/Apply button at the bottom of the web page.
In some cases, the radio may need to be rebooted in order for the changes to take effect. When
the reboot is necessary, the web page displays a message and a link to send the reboot command
to the radio.
Note: If your changes don’t show up in the configuration pages after clicking the Save/Apply button
and rebooting the Ethernet radio, you might need to power cycle the radio. Unplug the power
connector from the control board. Wait a few seconds and then plug the power connector back in.
When you have finished making changes to the Ethernet radio configuration, close the browser
window for the FreeWave configuration web site.
Radio Setup Settings
In the FreeWave configuration web server, click the Radio Setup option in the left navigation pane
to configure the general settings on the Ethernet radio.
Network Type
Configure the Network Type to Multi-Point for all Baseline Ethernet Radio units in your network.
Modem Mode
In the Modem Mode field, configure the setting for each radio according to its function within the
network. For example, make sure the Modem Mode field for the Gateway radio is set to Gateway.
When you are setting up Repeaters or Endpoints, make sure this field matches the function of the
unit.