Baseline Systems Ethernet Radio - Manual (Page 12)

Ethernet Radio Configuration Guide
Page 6 Section 1 – Configuring the Radios
Step 7 – Verify that the Controllers Are Connected to
BaseManager
Depending on how the network is configured at the site, the network administrator may need to
set up port forwarding in a router and/or change firewall settings in order to allow the radio
network to send and receive data over the Internet.
1. Go to one of the Baseline controllers that has a radio Endpoint installed.
2. Go into the network settings on the controller to ensure that it is using an Ethernet
connection. Even though the radio in the controller is set to a static IP address, the controller
itself should continue to use DHCP to obtain an IP address from the server.
Note: In some cases, a network administrator may want the controller to have a static IP
address. If you need to configure this, refer to Setting Up a Static IP Address in the controller’s
user manual.
3. The controller displays an activation PIN. Write down the PIN.
4. You can add these controllers to your BaseManager account using the Admin tool in
BaseManager. If you do not have a BaseManager account, call Baseline to set one up.
(Baseline Support 866.294.5847)