B&G Triton Display - Manual (Page 7)

| 5
Operation | Triton Operation Manual
Operation
The B&G Triton system is a networked multifunction instrument display and Pilot controller.
The display shows speed, depth, heading, position, wind and environmental data measured
by sensors and other equipment connected to the system.
Navigational data, engine/battery status and vessel parameters such as accumulated log and
rudder angle may also be displayed.
The instrument calculates speed trim, wind, trip distance and time, average speed, set and
drift parameters. A race timer is also included.
If a compatible autopilot is installed and connected to the same network it can be controlled
by the Pilot controller.
The Triton Display and Pilot Controller
1
5
7
6
8
9
4
3
2
1 Display
2 Menu / Enter key
Used to enter the main menu, select sub menus and confirm selection.
¼ Note: Press and holding the Enter key for 3 seconds takes you directly to the display setup
lighting level screen. If the lighting level is set below 5 it will automatically increase to 5. Use
the up and down keys to set the desired level and press Enter to confirm.
3 Page key
Scrolls through the eight default display pages and navigates back a step in menus.
¼ Note: the eight default display pages including Pilot page can be customized to display the
required data.
4 Directional keys
Scrolls up and down through selected menus / set values.
5 Pilot Controller
6 Mode key
Changes the Pilot mode.
7 STBY key
Disengages the autopilot.
8 Course control keys
Changes target course / Activates Non Follow Up (NFU) mode when in Standby mode.
9 Auto key
Engages the autopilot.
1