B&G Triton Display - Manual (Page 17)

| 15
Operation | Triton Operation Manual
Timer
The timer can be used as a countdown timer to a race start and as a means of measuring the
time elapsed after a race start or for any other timed operation.
¼ Note: The timer is by default shared between interconnected displays on the network. All
timer values will be identical.
The timer can be started at any time by selecting Start Timer from the timer setup menu. If
the Start value is set to zero (00:00) when the timer is started the timer will begin counting up,
recording the elapsed time.
¼ Note: The timer set value is in hours : Minutes, the timer counter will show Minutes : Seconds
with the hours in the top right hand corner of the display.
Countdown Timer
If you want to count down to a race start a time value can be set in the Start Value field in
the timer setup menu. When a time is present in the start value field the timer will begin to
countdown from that number when the timer is started. Once the time reaches zero it will
begin counting up recording the elapsed race time.
¼ Note: Time format = Hours (Shown in the top right-hand corner) Minutes : Seconds (MM:SS).
Start Value
To set a start value. Highlight and select Start Value. Pressing the ‘Page’ key will scroll through
the race timer digits from left to right. When the desired number is highlighted, scrolling up
and down will change that digit. Once complete press ‘Enter’ to confirm.
¼ Note: Minimum timer value greater than zero is one minute.
Start/Stop Timer
Once a start value has been set, to start the timer, highlight Start timer and press ‘Enter’. The
display will turn to the timer page and begin counting accordingly. To stop the timer from
counting select Timer Setup , highlight Stop Timer and press ‘Enter’.