B&G Triton Display - Manual (Page 33)

| 31
Setup | Triton Operation Manuali
Display mode
There are 3 display functionality modes. Highlight the desired mode and press ‘Enter’ to select.
Instrument display only
Displays instrument data only. No Pilot data page is viewable.
Pilot display only
Displays Pilot data only. No instrument data pages are viewable.
Pilot when engaged
Possible to view instrument data pages at all times and Pilot data when a Pilot system is
installed and connected to the network.
¼ Note: The Pilot page is automatically displayed when the Pilot is engaged.
Display setup
Set the light zone, enter night mode and change the lighting level.
¼ Note: Press and holding the ‘Enter’ key for 3 seconds takes you directly to the display setup
lighting level screen. If the light level is set below 5 it will automatically increases to 5. Use the
up and down keys to set the desired level and press ‘Enter’ to confirm.
Lighting zone
Set the lighting zone on the display. All units in the selected lighting zone will mirror each
others light settings. Default setting is Network.
Night mode
Change the display to night mode colour pallet. All displays in the selected lighting zone will
also change to night mode.
Lighting level
Adjust the back light level from 1 - 10.