B&G Triton Display - Manual (Page 25)

| 23
Setup | Triton Operation Manuali
Setup
Sources
A data source can be a sensor or a device connected to the NMEA2000 network, providing
information and commands to other networked devices. The data sources are normally
configured at first time turn on. It should only be necessary to update this data if a new
source is added, source is missing (sensor failure), source has been enabled/disabled, sensor
replaced or a network reset.
Auto select
The Auto select option will look for all sources connected to the instrument system. If more
than one source is available for each item, the display will automatically select from the
internal device priority list.
1: Verify that all interfaced units are powered on
2: Press the ‘Enter’ key to start the auto select procedure
The operator will be noted when the auto select process is completed.
¼ Note: If more than one source is available on the network you can chose your preferred
source from the sources menu. See Manual source selection for more information.
2