B&G Triton Display - Manual (Page 49)

| 47
Autopilot Setup | Triton Operation Manual
Autopilot settings
Installation menu
Warning: The installation settings must be performed as part of the
commissioning of the Pilot system. Failure to do so correctly may pro-
hibit the Pilot from functioning properly! The Installation menu can only
be accessed in Standby mode.
¼ Note: Some important points regarding the installation settings:
• When the Pilot is delivered from factory and ANY TIME AFTER AN AUTOPILOT RESET HAS
BEEN PERFORMED, the installation settings are all reset to factory preset (default) values. The
automatic interface prompt will appear and a complete setup has to be made.
• The Sea trial settings are dependent on successful completion of the Dockside settings.
¼ Note: If you select the Pilot page and the Pilot has not been commissioned you can go
straight to the commissioning page by selecting Setup.
Commissioning
Before the Pilot can be used you must first commission it and complete all of the dockside
procedures before it is operational.
4