B&G Triton Display - Manual (Page 40)

38 |
Autopilot | Triton Operation Manual
Pilot controller
AUTO
10 10
1 1
MODE STBY
Keys
The Pilot controller is operated by 7 keys. These are used to operate the autopilot and adjust
autopilot parameters.
Connectors
The Pilot controller is equipped with 1 network connector at the rear.
Network
The Pilot controller can be connected at any point on the network.
Keys Function
Mode: Changes the autopilot mode.
When the autopilot’s boat type is set to Sail and Auto mode is engaged,
pressing the mode key will change the autopilot to Wind mode. If the
autopilot is set for any other boat type and the autopilot is in Auto
mode, pressing the mode key will enter the autopilot into NoDrift
mode. For all boat types, when in Auto mode a long key press of the
mode key will enter the autopilot into Navigation mode which will
require confirmation via the display before it is engaged.
STBY: Disengages the autopilot. Places the autopilot into Standby mode.
Left 1: Adjust the set course or wind angle 1 degree / steer to Port in
Non Follow Up mode (NFU). When pressed in Standby mode this will
enter the autopilot into Non Follow Up mode.
Right 1: Adjust the set course or wind angle 1 degree / steer to
Starboard in Non Follow Up mode. When pressed in Standby mode this
will enter the autopilot into Non Follow Up mode.
Left 10: Adjust the set course or wind angle 10 degrees / steer to Port
in Non Follow Up mode. When pressed in Standby mode this will enter
the autopilot into Non Follow Up mode.
Right 10: Adjust the set course or wind angle 10 degrees / steer to
Starboard in Non Follow Up mode. When pressed in Standby mode this
will enter the autopilot into Non Follow Up mode.
Auto: Engage the autopilot / Acknowledge tack/gybe or navigation
course change.