Amico SSM Monitor Arms (Side to Side) - Manual (Page 5)

www.amico.com 2
Pre-Installation Information
Please Read Carefully Before Starting
WARNING: Verify that rails have been installed in accordance with Amico rail installation instructions. Rail failure
with devices mounted can cause serious injury and equipment damage.
WARNING: It is dangerous to use the arm for weights outside of the rated range. Structural failure and/or serious
injury could result.
WARNING: Do not position the SSM Monitor arm above a patient.
WARNING: It shall be the responsibility of the hospital, its consultants and/or contractors to determine if the wall
is adequate to safely mount the specific instrument. This includes the selection of appropriate fasteners and the
proper installation, regardless of what is supplied with your SSM Monitor arm. See Rail Instructions for specific wall
channel guideline information.
WARNING: Verify the weight of the device to be mounted. Single arm SSM monitor arms are rated for 30 lbs , dual
arm SSM monitor arms are rated for 15 lbs (Please refer to weight rating label, located either on the top or bottom
of the arm assembly, depending on the model). Check that the device to be mounted does not exceed the weight
rating. Serious injury and damage to the arm can occur as a result of overloading arm assembly.
For installation on non-Amico rails, ensure the rail is safe for the application.
If you are unsure of your application, please contact an Amico Accessories product specialist. 1-877-264-2697
Considerable efforts have been made to ensure the safety of your hospital staff and your patients. The installation
itself is beyond the control of Amico Accessories. Accordingly, Amico Accessories will not be responsible for failure
related to the installation of the product.
Contact Amico Accessories to discuss solutions not covered in this manual: 1-877-264-2697