Great Plains NP30A 30-foot Predelivery Manual - Manual (Page 21)

Great Plains Manufacturing, Inc. Table of Contents Index Install Components 17
08/30/2011 Table of Contents Index 407-313Q
Install Center Gauge Wheels
This applies to Pull-Type implements only. These may be
shipped with just the wheel assembly removed.
For 2-Point, 3-Point, or for a Pull-Type with the gauge
wheels already installed, continue at “Install Transport
Rest” on page 18.
• If the implement was shipped unfolded, install all four
gauge wheels.
• If the implement was shipped folded, install only the
two center section gauge wheels at this time. The wing
gauge wheels are installed at “Install Pull-Type Wing
Gauge Wheels” on page 23.
• Do not activate the lift circuit as part of this installation.
• Do not install lock channels as part of this installation.
Refer to Figure 22
62. At each gauge wheel mount where a wheel/arm
assembly is to be installed, remove and save
six sets of:
803-021C NUT HEX 5/8-11 PLT
804-022C WASHER LOCK SPRING 5/8 PLT
802-057C HHCS 5/8-11X2 1/4 GR5
two:
161-040D AXLE TUBE BUSHING MACH.
and one set of:
2A0134 MW COTTER PIN
805-124C PIN CLEVIS 1 X 3 11/16 GR5 PLT
63. Hoist a wheel arm tube into alignment with the
mount holes. Secure the alignment by re-inserting
the axle tubes
.
64. Secure the axle tubes with bolts , lock
washers and nuts .
65. Align the arm lug with the clevis of the cylinder
rod. Secure with clevis pin and cotter pin .
66. Repeat step 63 through step 65 for remaining
gauge wheel(s) to be installed at this time.
Continue at topic “Install Transport Rest” on page 18.
Figure 21
Hydraulic Gauge Wheels on Trailer
31704
Figure 22
Hydraulic Gauge Wheel
31705
12
49
64
57
67
17
1
57
64
49
12
17
67
12
49
64 57
1
67 17