Great Plains NP30A 30-foot Predelivery Manual - Manual (Page 11)

Great Plains Manufacturing, Inc. Table of Contents Index Unload Trailer 7
08/30/2011 Table of Contents Index 407-313Q
Unload Miscellaneous Components
Refer to Figure 3
1.
Use hoists or fork lifts to remove all pallets, crates
and loose sub-assemblies from the trailer bed.
2. Check serial numbers on components and crates
against the serial number plate of the implement.
If the shipment included multiple implements, partic-
ularly for multiple destinations, it is critical to unload
all (but only) the extra components for the imple-
ment.
Falling Implement Hazard:
Do not release any chains or straps securing the applicator
itself to the trailer bed until the applicator is fully supported by
the lifter(s). Some applicator configurations could tip to one
side or the other if not tied down or fully supported. This could
result in equipment damage, serious injury or death.
Pre-Lift Inspection
Pull-Type Anhydrous without Coulters
Have stands or supports available for Pull-Type anhy-
drous implements that have no coulters. This configura-
tion does not have any front support until after the gauge
wheels are installed.
Any Model Shipped Unfolded
Refer to Figure 5
3.
If the implement was shipped unfolded, verify that
there are wing pivot blocks
at both wing pivots. If
a block is missing at either wing, contact the factory.
If the wings are not blocked, they will droop at lift,
and coulter/knife damage is possible when the
implement is set down.
Figure 3
Crate and Tongue
31681
4
4
Figure 4
Pull-Type NH
3
No Coulter Tip Risk
31690
Figure 5
Wing Pivot Shipping Block
31681
5
5