Great Plains YP825A Operator Manual - Manual (Page 29)

Great Plains Manufacturing, Inc. Table of Contents Index Operating Instructions 25
2014-08-15 Table of Contents Index 401-651M
Transport Steps
Transport only with markers stowed (page 45).
1. Check that planter is securely hitched to a sufficient
tractor (page 14).
2. Always use a locking-style hitch pin sized to match
holes in hitch and draw-bar (minimum
1-inch-diameter, heat-treated pin).
3. Attach safety chain to tractor with enough slack to
permit turning (page 14).
4. Verify correct operation of lights.
5. Fold markers if unfolded (Option, page 45).
6. Raise planter (page 22).
7. Install cylinder locks (page 23).
8. Unload hoppers and tank(s) before transporting if at
all possible. The planter can be transported with a
full material load, but the added weight increases
stopping distance and decreases maneuverability.
Increased Hazards and Wear Risks:
Seed may be loaded prior to travel, but increases stopping
distance, increases the need for caution in turns and braking,
and increases tire wear.
9. If any seed is in hoppers or delivery hoses, close
seed inlet shutters at meters (page 77).
10. Check that tires are properly inflated (page 137).
11. Plan the route. Avoid steep hills.
12. Always have lights on for highway operation.
13. Do not exceed 32 kph (20 mph). Comply with all
national, regional and local laws when traveling on
public roads.
14. Remember that the planter may be wider than the
tractor. Allow safe clearance.
15. Transport slowly over uneven or rough terrain.