Preparation and setup, Initial setup, Post-delivery/seasonal setup – Great Plains YP825A Operator Manual User Manual
Page 17: Pre-planting setup

2014-08-15
401-651M
Great Plains Manufacturing, Inc.
13
Preparation and Setup
This section helps you prepare your tractor and YP425A,
YP625A and YP825A Planter for use, and covers tasks
that need to be done seasonally, or when the tractor/
planter configuration changes.
Before using the planter in the field, you must hitch it to a
suitable tractor, inspect systems and level the planter.
Before using the planter for the first time, and periodically
thereafter, certain adjustments and calibrations are
required.
Initial Setup
See “Appendix B - Pre-Delivery” on page 155 for
pre-delivery items (normally completed by dealer), and
first-time/infrequent setup tasks, including:
• Install seed monitor console in tractor (page 163).
• Set marker extension (Option, page 165).
• Install any Options not factory- or dealer-installed.
Post-Delivery/Seasonal Setup
On initial delivery, use with a new tractor, and seasonally,
check and as necessary, complete these items before
continuing to the routine setup items:
• Bleed hydraulic system (page 104).
• De-grease exposed cylinder rods if so protected at last
storage.
Pre-Planting Setup
Complete this checklist before routine setup:
❑ Read and understand “Important Safety
❑ Check that all working parts are moving freely, bolts
are tight, and cotter pins are spread.
❑ Check that all grease fittings are in place and
lubricated. See “Lubrication” on page 110.
❑ Check that all safety decals and reflectors are
correctly located and legible. Replace if damaged.
See “Safety Decals” on page 6.
❑ Inflate tires to pressure recommended and tighten
wheel bolts as specified. See “Tire Inflation Chart”
on page 137.