Great Plains YP825A Operator Manual - Manual (Page 25)

2014-08-15 Table of Contents Index 401-651M
Great Plains Manufacturing, Inc. Table of Contents Index 21
Operating Instructions
This section covers general operating procedures.
Experience, machine familiarity, and the following
information will lead to efficient operation and good
working habits. Always operate farm machinery with
safety in mind.
Pre-Start Checklist
Perform the following steps before transporting the
YP425A/625A/825A planter to the field.
❑ Carefully read “Important Safety Information” on
page 1.
❑ Fertilizer Option: Review the application instructions
and Material Safety Data Sheet (MSDS) for the
fertilizer(s).
❑ Install seed disks appropriate for crop. See
“Air-Pro
®
Meter Disk Installation” on page 76.
❑ Lubricate planter as indicated under “Lubrication”
on page 110.
❑ Check all tires for proper inflation. See “Tire
Inflation Chart” on page 137.
❑ Check all bolts, pins, and fasteners. Torque as
shown in “Torque Values Chart” on page 137.
❑ Check planter for worn or damaged parts. Repair or
replace parts before going to the field.
❑ Check hydraulic hoses, fittings, and cylinders for
leaks. Repair or replace before going to the field.
High Pressure Fluid Hazard:
Relieve pressure and shut down tractor before connecting,
disconnecting or checking hydraulic lines. Use a piece of
paper or cardboard, NOT BODY PARTS, to check for leaks.
Wear protective gloves and safety glasses or goggles when
working with hydraulic systems. Escaping fluid under pressure
can have sufficient pressure to penetrate the skin causing
serious injury. If an accident occurs, seek immediate medical
assistance from a physician familiar with this type of injury.