Great Plains 3N-4025P Operator Manual - Manual (Page 99)

4/23/2010 196-286M
97 Veris Drive Operating Instructions
Refer to Figure 8
Enter drill width here using Up/Down arrow keys.
Press Function key to advance to next window.
Refer to Figure 9
Enter number of rows here using Up/Down arrow
keys. Press Function key to advance to next
window.
Refer to Figure 10
Enter your planned planting speed using Up/
Down arrow keys. Calibration mode will not ac-
cept a speed higher than 10 mph. Press Function
key to advance to next window.
Refer to Figure 11
Enter the amount of seed you want to measure.
For volumetric metering, this should be at least
1/4 of a lb. For singulated metering, at least 100
seeds should be selected. Press Function key to
advance to next window.
22779
24003
22721
22780
Figure 11
Figure 10
Figure 8
Figure 9