Great Plains 3N-4025P Operator Manual - Manual (Page 72)

3N-4010P, 3N-4015P, 3N-4020P and
3N-4025P
196-286M 4/23/2010
70
Cleaning Out Meters
NOTE: Shut off sliding seed tubes before at-
tempting to clean out seed meters.
For seed meter clean out:
Refer to Figure 96
1. Position tarp or buckets under the opener(s)
whose meter(s) you will be cleaning out.
2. Remove retaining clip and pull pin.
Refer to Figure 97
3. Pull up on meter clean-out door to open.
4. When meter is empty, push meter clean out
door back to its original position to close.
NOTE: You may need to shake the clean out
door a little before closing to make sure all
seeds fall out.
5. Replace pin and retaining clip.
NOTE: The pictures for cleaning out meters
show meters for the 10, 15 and 29 series
meters. The procedure for the 25 series meter
is the same.
Finger Pickup Meter
1.
Place a bucket or pan under meter to catch
any seed during cleanout.
Refer to Figure 98
2. Pull cleanout door away from the opening and
allow seed to fall.
3. When meter is empty, push meter clean out
door back to its original position to close.
Clean out door
19190
19192
Figure 96
Figure 97
Figure 98
21920