Great Plains 3N-4025P Operator Manual User Manual
Page 102
3N-4010P, 3N-4015P, 3N-4020P and
3N-4025P
196-286M
4/23/2010
100
Refer to Figure 20
A new calibration number is suggested, along
with the old calibration number. Press Function
key to advance to the next window.
Refer to Figure 21
If you wish to keep the old number, perhaps to re-
run the calibration procedure, press the Down
arrow key. If you want to accept the new calibra-
tion number, press the Up arrow key.
Refer to Figure 22
Console window now displays the calibration
number you have selected. This returns you back
to the beginning of calibration mode. To rerun the
calibration procedure, follow the steps outlined
above. It is suggested that you perform the cali-
bration mode at least twice, and additional
replications may be needed if target and actual
amounts vary significantly.
22786
22731
22787
Figure 20
Figure 21
Figure 22