Great Plains 3PYP Predelivery Manual - Manual (Page 57)

Tractor Setup and Options 53
07/19/2011 401-312Q
Electronic Sensor Optional Adaptor Harness
Refer to Figure 92, Figure 93 and Figure 94
If obtaining the tractor wheel angle signal from the CAN-
bus on the tractor is not possible, the signal can be
obtained directly off the electronic sensor. To do this, an
adaptor harness is required. The appropriate harness is
used to tap into and monitor the existing steering angle
sensor signal from the tractor. There are currently three
variations of this harness:
John Deere Track Tractors
Required for all John Deere tracked tractors.
833-546C HARNESS JD WHEEL ANGLE SENSOR
TRACK TYPE
John Deere Wheel Tractors
Required for non-ISO compatible wheeled tractors.
833-548C HARNESS JD WHEEL ANGLE SENSOR
WHEEL TYPE
Case/New Holland Wheel Tractors
Required for all Case and New Holland tractors that are
factory equipped as auto-steer ready or have factory
installed auto-steer.
833-544C HARNESS CNH WHEEL ANGLE SEN-
SOR WHEEL TYPE
The 3-pin connector end of the adaptor harness con-
nects to the 3-pin connector end of the module master
harness.
Null4:
Figure 92
Optional Adaptor Harness
31816
70
71
69
1
1
1
70
70
71
71
Null4:
Figure 93
Module Master Harness
Signal Power IN
31833
2
69
69
Null4:
Figure 94
Module Master Harness
w/Case/NH Adaptor
31839
69
2
1
1
2