Great Plains 3PYP Predelivery Manual - Manual (Page 40)

36 3PYP
401-312Q 07/19/2011
Install Lower Walkboard Step
120. Select two:
816-634C STEP EXTENSION RUBBER
and fours sets:
802-091C HHCS 1/2-13X1 1/2 GR5
804-016C WASHER FLAT 1/2 SAE PLT
803-019C NUT LOCK 1/2-13 PLT
121. Insert the bolts from the inside of the bottom four
holes of the existing ladder . Align the rubber
extensions to cant out (following the angle of the
ladder) and place them over the bolt threads.
Loosely secure with washers
and lock nuts .
122. Select one:
401-591H STEP SINGLE BOLT-ON
and fours sets:
802-091C HHCS 1/2-13X1 1/2 GR5
804-016C WASHER FLAT 1/2 SAE PLT
803-019C NUT LOCK 1/2-13 PLT
123. Insert the bolts from the inside of the bottom four
holes of the new step . Align the rubber
extensions over the bolt threads. Add
washers and lock nuts . Secure all nuts
(tighten to Grade 2 specification).
Install Press Wheel Assemblies
Refer to Figure 66 and Figure 67
If any press wheel assemblies
were shipped sepa-
rately, or removed at step 22, install them now.
Note: With twin row planters, long and short press wheel
arm mount boxes are alternated every other row.
The long box is identified by the notches on its side
plate. The long box belongs on the right hand row
of a set of twins.
124. Remove and save the
1 ⁄
2
-13x1in hex head bolt and
washer at the back of one of the center row
units .
There are four bolts at this location. Remove only the hex head
bolts. Do not loosen or remove the square head bolts forward.
125. Remove and save the
1 ⁄
2
-13x1
1 ⁄
2
in hex head bolt ,
washer, and eccentric adjuster nut.
126. Align the
1 ⁄
2
in holes in the press wheel assembly
with the
1 ⁄
2
-13 tapped holes in the row unit, loosely
assemble with the
1 ⁄
2
-13x1in hex head bolt and
washer .
127. Loosely screw in the
1 ⁄
2
-13x1
1 ⁄
2
in hex head bolt ,
washer, and eccentric adjuster nut. Rotate the
adjuster to visually align the press wheel assembly
with the row unit, and tight the adjust and both bolts.
FigureSpacer:
Figure 65
Step Installation
29104
45
5
34
28
51
15
51
28
45
34
28
5
51
45 34
15
28
45
34
FigureSpacer:
Figure 66
Press Wheel Installation
25383
1
2 4
3
8
28
15
51
45 34
1
8
2
3
Null4:
Figure 67
Notches Identify Long Press
Wheel Box
32191
8
4
2
4