Great Plains 3PYP Predelivery Manual - Manual (Page 47)

Tractor Setup and Options 43
07/19/2011 401-312Q
Case IH MX/Magnum Installation
Refer to Figure 74 and Figure 75
The sensor
is installed at the forward top of the left
front axle.
10. Turn the tractor to the left to open room to work.
11. Select one:
411-579D BRKT SENSOR BASE TRACTOR
Case IH: Mount Inside (Base End) Bracket
Refer to Figure 75
12. Remove the existing forward bolt
.
Loosen the rear bolt .
13. Insert the long tab of the bracket with the short
tab facing left. If possible, align the inner hole
under the tractor bolt hole. If not possible, use the
end hole
. Secure with removed bolt .
Case IH: Mount Outside (Rod End) Bracket
Refer to Figure 74 and Figure 76 on page 44
14. Select one:
411-580D BRKT SENSOR ROD END CASE MX
15. Remove existing bolt . Using that bolt, secure the
short tab (with the larger holes) of the bracket
with the long tab facing forward and right. Use the
corner large hole
for the initial trial mounting.
16. It may be necessary to use the alternate large
hole when the sensor is fitted in the next steps.
Case IH: Check Sensor Extension
17. Turn the tractor front wheels straight ahead. Shut off
tractor.
18. Select the sensor assembly . Loosen the gimbal
collar . Gently pull the sensor rod to centered
extension, as determined at step 7 on page 42, with
yoke center bolt down, and rod-end bolt up.
Note: When trial fitting, make sure sensor does not con-
tact any tractor components. Use alternate mount
and pivot holes as necessary to obtain clearance.
19. Determine which bracket holes sensor fits. Mark
those holes, but do not mount the sensor at this
time. At the inboard end, use the left tab hole
if
possible.
If sensor is too short, move collar toward connector
end (base) of sensor. Do not block vent hole.
If sensor is too long, move outboard bracket to
alternate mounting hole. If sensor is still too long,
move collar toward rod end of sensor.
Note holes and collar position with a marker.
FigureSpacer:
Figure 74
Case IH Components
29202
51
56
3
4
57
5
62
64
58
63
6
7
8
9
61
51
56
a
b
56
3
4 a
57
c
57
7
FigureSpacer:
Figure 75
Case IH/MX Inboard Bracket
29208
a
56
b
8
51
58
5
57