Install fan, Install fan mount weldment, Relocate fan from shipping bracket – Great Plains 3PYP Predelivery Manual User Manual
Page 33: Step 85)

Planter Assembly 29
07/19/2011
401-312Q
Install Fan
The seed fan needs to be relocated from a shipping
bracket on the mainframe to a seed cart weldment. The
fan hoses and sensor harness are pre-connected.
Install Fan Mount Weldment
Refer to Figure 51
85. Locate the fan mount weldment:
401-518H BRKT FAN SIDE MNT WLDMT
Position it as shown on the left side of the front face
of the mated left arm flange.
86. Secure the mount and flanges by removing and re-
installing four sets of:
803-021C NUT HEX 5/8-11 PLT
804-022C WASHER LOCK SPRING 5/8 PLT
802-057C HHCS 5/8-11X2 1/4 GR5.
FigureSpacer:
Relocate Fan from Shipping Bracket
Refer to Figure 52
87. Remove and save four sets of:
803-014C NUT HEX 3/8-16 PLT
804-013C WASHER LOCK SPRING 3/8 PLT
802-017C HHCS 3/8-16X1 GR5
Refer to Figure 51
88. Relocate the fan to the weldment
installed at
step 86. Orient the outlet to face right. Secure to
weldment with saved fasteners from step 87.
89. Remove the shipping bracket
, U-bolt, washers
and nuts from the mainframe. These parts are not
re-used.
FigureSpacer:
Figure 51
Attach Fan Mount Weldment
27427
14
26
46
36
14
36
46
26
FigureSpacer:
Figure 52
Fan Mounted for Shipping
29165
24
43
33
1
33
43
24
14
1