Mount seed box frame, Seed cart self-lift, Remove cart shipping stands – Great Plains 3PYP Predelivery Manual User Manual
Page 26: Seed cart self-lift remove cart shipping stands

22 3PYP
401-312Q
07/19/2011
Mount Seed Box Frame
If tie rods are in crate, skip to step 39.
Refer to Figure 37
37. Cut the cable ties
securing the tie rods
flanges.
38. Remove the cotter pins from the castellated nuts
,
remove the nuts, and the tie rods. Save the tie rods
and fasteners for re-installation at step 68.
Refer to Figure 38
Note: If no hopper is included, leave walkboard closed,
and lift structure using 3 adequately sized chains
so it lifts evenly side-to-side and front-to-back.
39. Open the walkboard by removing the pin
, swing-
ing it open to the right, and securing it with the
keeper.
40. Lift the seed support structure from the rear using
the fork holes
in the hopper support.
Refer to Figure 39
Have the GR5 bolts
, washers
and nuts
saved
41. Position the flanges
on the front of the structure
to mate up with the corresponding flanges on the
rear of one of the two parallel arms. Secure with 16
bolts, washers and nuts.
Note: A fan mount weldment is added to the left flange
later (step 85).
42. Use the lift or hoist to align the flanges on the other
side. Secure with 16 bolts, washers and nuts.
Seed Cart Self-Lift
If only one hoist or fork lift is available (the one presently
supporting the seed cart structure), it will be needed for
hoisting casters. The lift-assist cylinders are capable of
supporting the entire weight of the seed structure if the
mainframe is hitched to a 3-point tractor, and the lift
hoses (blue) are connected to a tractor remote.
If you need to free the hoist/lift:
43. Lower the seed structure onto its shipping stands.
44. Hitch a 3-point tractor and connect the lift-assist cir-
cuit.
45. Raise the seed structure until the parallel arms are
slightly above level at the rear.
46. Put blocks or jack stands under the rear shipping
strands of the seed structure.
Remove Cart Shipping Stands
47. Remove the four shipping stands
from the seed
structure. These are not re-used.
FigureSpacer:
Figure 37
Remove Tie Rods
29156
2
1
3
4
FigureSpacer:
Figure 38
Seed Box Frame w/Hopper
25368
4
5
5
36
46
26
6
FigureSpacer:
Figure 39
Align Seed Box with Arms
29151
6
7
36 46 26
7
7